Installing and setting the Magnetic
Contact Detectors
Ensure that the system is in Test mode.
1.
Remove the battery cover by sliding and lifting it
off. (DO NOT use a screwdriver to lever off).
2.
Remove the battery holder by carefully tilting up
the end and pulling the connector off the printed
circuit board.
3.
Mount the Magnetic Contact Detector to the fixed
part of the frame along the opening edge opposite
the hinges using either the double sided adhesive
tape or screws provided.
When fixing the Magnetic Contact Detector with
screws, the top of the Detector is secured with a
keyhole slot over the screw head of the smaller pan
head screw. The bottom is secured using the 12mm
countersunk head screw fitted within the battery
compartment. Carefully drill out the centre of the
fixing screw hole in the battery compartment using
a 3mm drill. Do not over-tighten the fixing screws
as this may distort or damage the casing.
4.
Fit the Magnet to the moving part of the door/
window opposite the Magnetic Contact Detector
using the two 15mm fixing screws. Ensuring that
the parallel gap between the Magnet and Detector
is less than 10mm and that the arrow on the
Magnet is pointing towards and aligned with the
mark on the top section of the Detector.
5.
If an additional wired Magnetic Contact Detector is
required, this should be wired to the terminal block
provided in the battery compartment. The wired
contact should be connected using two core
(24AWG) wire of maximum length 1.5m.
Important: If an additional wired contact is not
connected, then the jumper link SW2 must be fitted for
the Magnetic Contact Detector to operate correctly.
6.
Set the House Code for the Magnetic Contact
Detector by setting DIP switches 1-8 to the same
ON/OFF combination as the House Code DIP
switches in all other system devices.
7.
Set the alarm zone which the Detector will operate
on with DIP switches 9-11 as follows:
Magnetic Contact Detectors
13
Battery
Connector
Tilt and Remove
Battery Holder
and Insert
Two Batteries
Double Sided Tape
OR Screw Fixing
Raised Head Screw
Key-hole Slot Fixing
(underside)
Small Counter-sunk
Screw Fixing
Slide Open and Lift Off
Do Not Use A Screwdriver
Detector
Magnet
Cut-out for
Cable Entry
Battery Cover
Alternative
Mounting
(Ensure
back
surfaces
are flush)
ON
ECE
1 2 3 4 5 6 7 8 9 10 11 12
8mm
11mm
Terminal Block for Additional Wired
Magnetic Contact Detector T1
Anti-Tamper
Switch SW2
Location of
Key-hole Screw
(underside)
Jumper
Link S2
Hole for
Mounting
Screw
Batteries
x 2
ON
1 2 3 4 5 6 7 8 9 10 11 12
Zone
House Code
ECE
Dip Switch
12 Not Used
Zone 1
Zone 2
Zone 3
Zone 4
Zone 5
Zone 6
DIP 9
OFF
OFF
OFF
OFF
ON
ON
DIP 10
OFF
OFF
ON
ON
OFF
OFF
DIP 11
OFF
ON
OFF
ON
OFF
ON
