Connect the BT plug on the other end of the lead
to an appropriate telephone outlet.
If the cable supplied is not long enough to reach a
suitable phone point then it will need extending
using a coupler and extension lead (not supplied).
Note: If the Panel Tamper alarm sounds during the
installation reset the alarm by pressing:
on the Control Panel Keypad.
Setting the Control Panel
House Code
With the unit in Standby mode (Power LED only
illuminated).
1.
Press
The Control Panel will beep twice and the Arm and
Part-Arm LEDs will illuminate. All Zone, Fire and
Tamper LEDS will flash.
This puts the Control Panel into programming mode.
2.
Press
The Zone LEDs 1-6, Fire and Tamper LEDs will
illuminate to indicate the current House Code
setting with an illuminated LED indicating a setting
of ‘ON’ and LEDs not illuminated indicating a
setting of ‘OFF’. For example, a house code of
‘ON’, ‘ON’, ‘ON’, ‘ON’, ‘OFF’, ‘OFF’, ‘ON’, ‘OFF’,
will be indicated with zone LEDs 1 - 4 illuminated,
Zones 5 & 6 ‘not illuminated’, Fire Zone ‘illuminated’
and Tamper Zone ‘not illuminated’.
3.
The system House Code can be set either directly
at the Control Panel or via a Remote Control Unit.
At the Control Panel:
a) By pressing buttons 1-8 on the Control Panel,
setting the status LEDs so that they indicate
the required house code setting. The LEDs will
switch to the opposite state each time the
button is pressed.
LED ON = 1, (House Code DIP Switch On)
LED OFF = 0, (House Code DIP Switch Off)
b) Press to save the new setting and return
to programming mode.
b) Press to return to programming mode
without saving.
Using a Remote Control Unit:
a) With the required House Code already set on
the remote control, press the button on
the Remote Control.
The Control Panel will beep twice to
acknowledge the signal.
The Zone, Fire and Tamper LED status will
be updated to correspond with the House
Code set on the Remote Control and now
programmed into the Control Panel.
b) Press to return to programming mode.
4.
Press to exit programming mode and
return to Standby
5.
Press
The Control Panel will beep and the Arm and
Part-Arm LEDs will flash.
This puts the Control Panel into test mode.
Remote Control Unit
The Remote Control Unit is used to Arm, Part-Arm and
Disarm the system.
The Remote Control Unit also incorporates a Panic
switch. Activating the Panic switch on the side of the
Remote Control will immediately initiate a Full Alarm
condition whether the system is Armed or Disarmed.
The alarm can be cancelled by pressing the ‘DISARM’
button on the Remote Control or via the Control Panel.
Any number of Remote Control Units can be used with
your system, providing they are all coded with the
same system House Code.
9
1
2
3
4
,
,
Slide up
to operate
Transmit LED
Personal Attack
Disarm
Arm
Part-Arm
1
2
3
4
,
,
1
2
3
4
,
,
2
ESC
ESC
