21. Befestigen Sie die Montageplatte des unteren Kaminschachtes (Abb. d) mit zwei
ST4×40mm Schrauben an der Wand.
13. Setzen Sie die ineinandergeschobenen Kaminschächte auf die Haube.
18. Montieren Sie den Montagebügel (Abb. f) für den inneren Kaminschacht mit zwei
ST4×40mm Schrauben oben an der Decke an die Wand.
14. Ziehen Sie den inneren Kaminschacht im geradem Winkel bis oben an die Decke
und setzen Sie je einen Markierungsstrich seitlich am Schacht (Abb. e)
15. Entfernen Sie die Kaminschächte von der Haube.
16. Halten Sie den Montagebügel (Abb. f) für den oberen (inneren) Kaminschacht
mittig zwischen die gezogenen Markierungsstriche (Abb. e) ganz oben an die Decke
und markieren Sie durch die zwei Löcher (Abb. f) im Montagebügel die Bohrlöcher
mit einem Bleistift.
17. Bohren Sie mit einem 8mm Steinbohrer zwei 40 mm tiefe Löcher bei den
Bleistiftmarkierungen und setzen Sie zwei Dübel.
20. Schieben Sie den inneren Kaminschacht ganz nach unten.
19. Setzen Sie die zwei ineinander geschobenen Kaminschächte auf die Haube
22 . Fixieren Sie den unteren Kaminschacht mit zwei ST4*8mm Schrauben seitlich an
der Haube (Abb. g)
23. Ziehen Sie den oberen (inneren) Kaminschacht ganz nach oben und befestigen
Sie diesen mit zwei ST4*8mm Schrauben seitlich am Montagebügel. (Abb. h)
25. Montieren Sie die Kohlefilter seitlich am Motor. (Siehe Bedienungsanleitungs-
Kapitel "Einsatz der Kohlefilter"
24. Heben Sie die Hauben Front an, entfernen Sie den Fettfilter und befestigen Sie
die Haube von innen mit zwei ST4×30mm Schrauben durch die 2 Löcher in der
Hauben Rückwand, zur Sicherung der Haube. (Abb. i)
Abb. f)
Abb. g )
Abb. e)
Abb. h)
Abb. i)
fi200921at
3
/
4