DeltaSol
®
B Pro
© RESOL 04026 deltasol_b_pro.mon.pmd
Page 12/24
constantly green:
everything o.k.
red/green flashing:
initialisation phase
manual operation
red flashing:
sensor defect
3.2.13 LED blinking codes
The thermostat function works independently from the
solar operation and can e.g. be used for use of surplus
energy or after-heating. Factory settings: TO = 40 °C, TF =
45 °C
• TO = TF
the thermostat function is deactivated, in this case
relay output R2 is activated if the maximum store
temperature is exceeded
• TO < TF
the thermostat function is used for after-heating
• TO > TF
the thermostat function is used as use of surplus
energy
If the 2nd relay output is activated, in the display is
shown
.
3.2.11Thermostat function (
TO, TF
)
(System 4, FN=4)
After heating
use of surplus energy
The operating mode of the controller can manually be set
for control- and service works. Choose the adjustment
value MM, which allows the following adjustments:
3.2.12 Operation mode (
MM
)
• MM
=
M
ode
M
anual
Manual mode:
0 : Control lamp flashes red/green. Relay 1 and 2 off
1 : Control lamp flashes red/green. Relay 1 on, relay
2 off
2 : Control lamp flashes red/green. Relay 1 off, relay
2 on
3 : Control lamp flashes red/green. Relay 1 and 2 on
4 : Control lamp flashes green. Automatic operation
MM
R1
R2
0
off
off
1
on
off
2
off
on
3
on
on
4
auto
auto
