10
7.
General notes and information for assembly
a) General information
Take enough time for the assembly.
Hurrying often leads to mistakes that may damage components or ruin the time benefit
by elaborate rework.
The workplace should be sufficiently large and clean so that the different components and assemblies can be put down and
installed easily.
Always observe the images during assembly.
Here, the assembly locations and correct alignment of the components are
shown.
All mechanical components of the construction kit are produced extremely precisely.
Never apply any force during assem
-
bly.
All parts can be assembled without any great application of force.
If this is not the case, rethink the assembly step and
reread the corresponding description in these instructions.
When tightening the screws, ensure that you do not tighten them too tightly.
Many screws are turned into aluminium
threads and therefore must not be tightened as far as it would be possible, e.g., in steel threads.
If you install accessories directly when installing the construction kit, read these instructions before installing the construction kit,
since this will change some work steps.
The delivery includes some screws and slot nuts in larger numbers than necessary.
They are meant as replacements in case a screw
or similar material is lost in assembly.
For cylinder-head screws, the length (l) is measured without the screw head; for recessed-head screws, the length measurement
takes place with the screw head.
The diameter (d) is always measured by the thread.
b) Required tools
• Different screwdrivers (cross-head and slotted)
• Hex key 1.5 mm / 2 mm / 2.5 mm / 3 mm / 4 mm
• Hexagon socket wrench 4 mm / 5 mm / 5.5 mm / 6 mm / 7 mm
• Hexagon spanner 5 mm / 6 mm / 7 mm / 8 mm / 10 mm / 11 mm / 13 mm
A hexagon socket wrench or a hexagon spanner may be used in some cases.
• Wire cutter
• Small flat pliers and small long-nose pliers
• Feeler gauge 0.3 mm
