SHIPPING, RIGGING, LIFTING AND ASSEMBLY: LE MODELS
7
1.800.627.4499
INSTALLATION, OPERATION AND MAINTENANCE MANUAL
RENEWAIRE.COM
RIGGING
2.0 RIGGING
2.1 REQUIRED RIGGING EQUIPMENT
The unit comes equipped with base rail lifting lugs at the lower 4 corners and in the middle of the unit.
Each lifting lugs come equipped with a 2” diameter hole which will accommodate a 1.5” dia. schedule
40 steel pipe (not provided).
Unit or module sections shall be lifted by cables attached to all of the lifting lugs.
If cables or chains are used to lift the unit they must be the same length. Care should be taken not to
damage the cabinet, dampers, or electrical box.
Adjustable spreader bars should be used to properly support the unit in order to properly distribute
the load thus applying an even vertical lifting force to all of the lifting lugs. This will prevent structural
damage to the unit.
Also adjustable spreader bars should be used to maintain the required 10” clearance between the
cables and the cabinet or any of the equipment attached to the unit or modules.
Provide additional blocking or covering as required.
Secure hooks and cables at all lifting points.
Take up slack in cables gradually as to avoid sudden movements as this may cause the unit or modules
to shift.
Suspending the unit or modules for an extended period of time is not recommended and it is advised
to place the unit as soon as possible after lifting.
Do not lift in high winds.
RenewAire will not be responsible for any damage during the rigging, lifting or installing of the unit or
modules.
Refer to Corner Weight Charts for exact center of gravity.
All rigging equipment is to be provided by the installing Contractor.
Rigging procedures may differ depending on the physical dimensions of the unit or modules, it’s loca-
tion, the job site, or Installing Contractor preferences.
Tools needed (Suggested):
Crane to lift proper capacity
Adjustable spreader bars
Cables
1.5” Dia. steel pipe schedule 40.
Tools to pull modules together, chains, bar clamps, come alongs etc.
Miscellaneous (SAE) wrenches and 1/2” drive socket wrenches with short extensions
