SHIPPING, RIGGING, LIFTING AND ASSEMBLY: LE MODELS
RENEWAIRE.COM
INSTALLATION, OPERATION AND MAINTENANCE MANUAL
1.800.627.4499
14
ASSEMBLY
4.5.5 Install Assembly Straps
4.5.6 Install Roof End Joining Caps
Two (2) galvanized metal assembly straps are used to secure the module seams to assist in maintain-
ing a water and airtight seal and provide structural rigidity during lifting. One (1) used on each side of
the unit. These straps are provided with pre-drilled holes. #12 X 3/4” hex head tek screw w/washers
are provided to attach the joining straps to the unit. For additional protection, caulk sides of straps
after attachment.
For best results, use a lower torque setting on the power drill. Be careful not to over tighten the screw.
www.renewaire.com (800) 627- 4499
Two (2) galvanized roof cap ends are provided to seal the top end of each module and maintain a water
and airtight seal. The roof cap joining ends are provided with pre-drilled holes. #12 X 3/4” hex head
tek screw w/washers are provided to attach these roof cap joining ends to the unit.
www.renewaire.com (800) 627- 4499
NOTE: Failure to install the assembly straps will
compromise the structural integrity of the unit and
cause damage during lifting. It will also compromise
the water and airtight integrity of the unit.
NOTE: Failure to install roof cap ends will compromise
the structural integrity of the unit and cause unit
damage during lifting. It will also compromise the water
and airtight integrity of the unit.
Assembly Strap Locations
Assembly Strap Installation
Roof End Joining Caps
