SHIPPING, RIGGING, LIFTING AND ASSEMBLY: LE MODELS
11
1.800.627.4499
INSTALLATION, OPERATION AND MAINTENANCE MANUAL
RENEWAIRE.COM
ASSEMBLY
4.5 JOIN MODULES TOGETHER
4.5.1 Bolt Together at Lifting Lugs
Align modules and push together using forklift or other means, compressing the gasket tape. The
lower lifting lugs are equipped with 2” diameter holes that 1.5” dia. (2” OD) steel pipe could be used
to assist in alignment.
See Lifting Lug illustration on page 8 of this manual.
Joining lift lugs also have a
spacing bolt at the tip of one lug that will fit into the empty lug hole of the other module for alignment
and lug tip spacing.
After positioning the modules together, compressing the gasket tape, insert eight 3/8” - 16 x 1-1/4
plated hex head bolts through the holes on the lifting lugs and base rail (LE-IN) or base supports
(LE-RT) of the two adjacent modules. Use 3/8” washers between the bolt head and the unit and
between the nut and the unit. Fasten the nuts to the bolts secure the bases of the two modules
together tightly.
ALIGNMENT /
SPACER
BOLT
LE INDOOR UNITS:
INSTALL 2 BOLTS IN THE MATING LIFT-
ING LUGS AND THEN 2 MORE BOLTS
IN THE MATING BASE RAILS. TYPICAL
EACH SIDE OF LE UNIT.
2 BOLTS THROUGH LIFTING
LUGS (EACH SIDE OF UNIT)
HAND HOLES (TYP, EACH
SIDE OF UNIT)
2 BOLTS THROUGH LIFTING
LUGS (EACH SIDE OF UNIT)
2 BOLTS THROUGH BASE RAILS (EACH SIDE
OF UNIT). ACCESS BOLT AND NUT THROUGH
THE HAND HOLES IN EACH MODULE SIDE BASE
RAIL TO BE JOINED.
2 BOLTS THROUGH BASE SUP-
PORTS (EACH SIDE OF UNIT).
ACCESS BOLT AND NUT
THROUGH HAND HOLES IN
EACH MODULE SIDE BASE RAIL
TO BE JOINED.
LE ROOFTOP UNITS:
INSTALL 2 BOLTS IN THE
MATING LIFTING LUGS AND
THEN 2 MORE BOLTS IN BASE
SUPPORT.
LE Indoor Unit Base Bolt Locations
LE Rooftop Unit Base Bolt Locations
Alignment / Spacer Bolt Location
Module Positioning Technique
