SHIPPING, RIGGING, LIFTING AND ASSEMBLY: LE MODELS
RENEWAIRE.COM
INSTALLATION, OPERATION AND MAINTENANCE MANUAL
1.800.627.4499
16
ASSEMBLY
4.7 INSTALL WEATHERHOODS
Rooftop units (RT models) have weatherhoods that are shipped loose and must be field-installed.
Installation of the hoods is normally performed after all rigging and hoisting is completed because of
the chance of damage to the hoods by the rigging equipment.
All weatherhoods have a flange on the top rear that must be inserted behind the roof panel overhang.
To install any hood, remove the factory-installed roof edge screws and keep them for re-use.
www.renewaire.com (800) 627- 4499
www.renewaire.com (800) 627- 4499
www.renewaire.com (800) 627- 4499
www.renewaire.com (800) 627- 4499
Slide the top flange of the OA air hood beneath the roof panel overhang. Reinstall the screws in the roof
edge and then install screws along the sides and lower edge of each hood.
Slide the top flange of the EA air hood beneath the roof panel overhang. Reinstall the screws in the roof
edge and then install screws along the sides and lower edge of each hood.
OUTSIDE AIR HOODS
EXHAUST AIR HOODS
Replace the access cover by sliding the top edge of the cover behind the edge of the roof pan and
replace the screws. Caulk the sides and bottom of the access panel with factory-supplied caulk.
www.renewaire.com (800) 627- 4499
Access Panel Installation
OA Hood Screw Locations
EA Hood Screw Locations
OA Hood Installation
EA Hood Installation
