VILLAGIO OWNERS MANUAL
Renegade RV
574.848.1126
Page 97
Rev.712a
This owner’s manual is subject to change
Updates will be posted on our web site
AT WWW. Renegaderv.com
Manual Override
In the event that the slide out room fails to retract and manual operation is
required:
Locate the slide out control panel (located in passenger side compartment). Press the
Mode button 6 times, quickly. Press a 7th time and hold for approximately 5 seconds.
Red and
green LED lights will begin to flash, confirming the override mode.
Release Mode button.
• Use the slide out control switch (located inside the coach) to retract the room.
NOTE: If slide out room fails to retract using the Manual Override method, see "Slide out
Emergency Retraction" elsewhere in this section.
For further information s
ee the slide out room operating guide included in your Info Case.
10-5 SLIDEOUT EMERGENCY
RETRACTION (LIPPERT)
-(If equipped)
If the slide out mechanism is malfunctioning and the room will not retract using the interior
control switch or exterior control panel, you may need to access the slide out motors and
manually push the room in to the travel position. There are two slide out motors equipped on the
end wall of each slide out room. Pull back wipe seal to access motors.
Push-In Procedure
1. Remove slide out motor retention screw (located along exterior slide out trim), if equipped.
Repeat on opposite slide out trim.
NOTE: If your coach is not equipped with Slide out motor retention screws, proceed to Step
2.
Slide out Motor retention Screw (Located along exterior slide out trim)
-If Equipped
2. Pull back wipe seal to access slide out motor.
3. Using a flat-head screwdriver, push bottom of Slide out motor UP to disengage
(approximately 1/2" from base).
Repeat on opposite slide out motor.
Slide out Motor
(located
behind slide out wipe seal)
• Use a screwdriver to push slide out motor UP (disengage).
• Ensure slide out motor is disengaged
approximately 1/2" from base.
4. Push slide out room in to travel position, ensuring both sides are relatively even.
NOTE: Several people may be needed to push the room in.
5. When the slide out room is fully retracted, secure the room with a support item (e.g. 2x4
wood board) above the interior slide out room to secure room during travel.
NOTE: For larger slide out rooms, place a travel support item on each end of the interior slide
out room.
Slide out Travel Support.
• Place support item (e.g. 2x4 wood
board) above interior slide out room as
6. See your dealer for service of the slide out motors before using again.
For further information, p
lease refer to the slide out manufacturer's user guide provided in your
Info Case.
