VILLAGIO OWNERS MANUAL
Renegade RV
574.848.1126
Page 49
Rev.712a
This owner’s manual is subject to change
Updates will be posted on our web site
AT WWW. Renegaderv.com
To Replace the Air Gap
:
1. Tum off the Water Heater switch and
incoming water supply (city water and/or
demand pump).
2. Open a faucet in the motorhome to relieve water pressure.
3. Pull the handle of the P-T valve straight out and allow water to flow until it stops.
• Lift handle straight out to open
P-T valve when water heater is cold
4. Let the handle of the P-T valve snap shut.
5. Close the faucet and tum on the water supply before switching the water heater on.
Manually
operate the pressure temperature relief valve at least once a year.
NOTE: If your water heater is equipped with the Motor aid system, it uses an extension from
the engine cooling system to
heat
water in the water heater while driving. The engine cooling
system must also be cold before opening the pressure temperature relief valve. See "Moto raid
Water Heater" for more information.
4-8 PROPANE GAS FURNACE
To Start Up
1. Open the Propane Gas Tank valve by turning fully "counter-clockwise".
Thermostat Switch Temp Selector
• Move to Heat or Gas position for furnace operation
• Press up or down to select temperature
-Typical Villagio
2. Slide the Thermostat switch from Off to Heat and press the Temp Selector button (up/down
arrows) until the desired temperature is shown on the display.