Rendamax R2000 Series, Техническая документация инструкция

Страница: 9 / 52

DOC2012/2000en
9
1.5 Reservation
It is the law that the installation be carried out by a competent person. The boiler should be in-stalled in
accordance with the British Standards and Codes of Practice referred to in this manual, the Gas Safety
(installation & use) Regulations 1994, Building Regulations, Model Water Bye-laws and any Require ments of
the Local Gas Supplier, Local Authority, Water and Fire Authorities and I.E.E. Regulations.
Health & Safety at Work Act, 1974
Under Section 6 of the above Act, it is the duty of manufactur ers and suppliers of products for use at work to
ensure, so far as it is reasonable practicable, that such products are safe and without risk to health when properly
used and to make available to users of such products adequate information about their safe and proper operation.
Rendamax boilers should only be used in the manner and purpose for wich they were intended, and in accordance
with the recommendations detailed in this manual. Our heaters have been designed, produced and inspected with
safety in mind, but there are certain basic precautions, wich should be taken by the user and, in particular attention
is drawn to the safety precautions in this manual and to the operating instructions on the heater. It is imperative,
therefore, that all persons who make use of our heaters have all the information and instructions they require to
ensure that they are fully aware of any hazard, and that they know both the purpose and correct manner of use of
our heaters.
The manufacturer can alter its products without any preceding notification and is therefore not obliged to
adapt earlier delivered products.
2 Description
2.1 General information
The R2000 series boilers are atmospheric open flued, low thermal capacity gas-fi red boilers.
These high efficiency boilers are designed to provide heating and hot water services for a wide variety of
industrial and com mercial premises.
The R2000 series of boilers are available in 12 types:
R2017, R2022, R2028, R2034, R2041, R2048, R2056, R2066, R2077, R2090, R2105, R2122.
The last three digits of the type number indicate the number of burner bars present in the burner assembly.
The load at nett calorific value is approx. 3,5 kW per burner.
All boiler types are fitted with a 9-tube heat exchanger of the 2 pass type.
The use of extruded copper fin pipes in the heat exchanger leads to higher effi ciency.
Thermal radiation losses are minimized by the optimal construction of the combustion chamber in
which high-grade insu lation is integrated.
The advanced construction of the R2000 enables swift assem bly and dismantle, which simplifi es
maintenance and inspection.
All boilers have full sequence automatic control with overheat cut off, water flow switch, modulating turn
down on gas and combustion air (for improved efficiency at varying heat loads) and fault indicators.
The R2000 has an
electronic protection and ignition system, indicated by E.
The electronic PID version controlled by a simple to operate regulator is indicated in the M version.
The weather compensation version with night reduction is indicated in the W version.
Appliance category B11.
The R2000 series is CE approved for the following countries:
Great Britain, Belgium, Denmark, France, Ireland, Italy, Spain and Sweden under Product
Identification Number 0063AQ6600.