RENA XPS-80/90
User Guide
5-25
U2
= adjust carriage pairs within print unit U2
no
= abort the procedure without making changes.
•
Press the
enter
key to accept the selection
•
Press the
prev
or
next
key to select the relevant cartridge pair.
< > =
or
< > =
•
Press the
enter
key to accept the selection
•
Set the correct value with the
prev
or
next
key if required for
these two cartridges.
Value range:
+24 to –24, one increment = 0.08mm (= 1/300“)
Positive values shift the print image of a cartridge to the left,
negative values to the right. Start with small corrections.
•
Press
pap
to perform an alignment test pattern, shown below
(size greatly reduced).
•
If the alignment is not correct, repeat the two previous steps
until the misalignment has disappeared.
•
Press the
enter
key – the value is saved.
•
Note
: This calibration must be performed for all cartridge pairs,
which show a misalignment, until all the bars in the alignment
test pattern are properly aligned.
•
End the procedure with
end
.
Cartridges horizontally aligned
Cartriges not horizontally aligned
Содержание XPS-80
