fig.
III. Installation
(continued)
fig.
13. Push in the red pressure
release valve located on the
pre-filter housing (see figure
11) to allow air to escape.
When only water starts to
escape, release the valve.
Wipe any water released
through the pressure release
valve off the pre-filter housing.
Filtered water should now
be flowing out of the small
nozzle on the diverter valve or
spout. Allow the water to flow
through the AQUA
3
II for
ten
minutes
to purge the system.
Sudden bursts of water and
air are normal—the system is
eliminating air pockets.
14. With the water running, check
for leaks—run your hands
around all openings. Turn the
unit upside down and rest it
on the filter housings, and
remove the base by pushing
in on the base release buttons
on the front and back of the
manifold (see figure 12).
Check for leaks around the
flow-meter. If there are any
leaking connections, turn the
tap off and try tightening or
re-connecting the problem
section.
15. Snap the base back into
place and turn the AQUA
3
II
upright.
16. Replace the AQUA
3
II body-
cover. Position the AQUA
3
II
on the counter. Your new
AQUA
3
II is now ready for
use.
Содержание AQUA II 5000
Страница 1: ... Use Care ...
Страница 7: ... A Q R O P L C M I N K S T U D H W B G J V F E X Z Y D ...