Rena Ware AQUA II 5000, Руководство пользователя

Страница: 9 / 28

9
fig. 5
fig. 4
III. Installation
(continued)
pointed downward, apply
a sliding pressure straight
down—then twist to slide the
pre-filter ceramic candle into
place. Make sure it is pushed
all the way down.
5. REPLACE THE PRE-FILTER
HOUSING—Check to make
sure that the O-ring is in place
at the open end of the pre-
filter housing. (If the O-ring
falls out, lay it back into the
groove at the opening of the
filter housing (see figure 4)
and press into place with your
fingers. A small amount of
petroleum jelly can be applied
to the O-ring to help hold it in
place. Do not use vegetable,
animal or motor oil.) Place the
pre-filter housing over the pre-
filter ceramic candle and turn
clockwise until hand-tight. DO
NOT OVER-TIGHTEN. Never
use the housing wrench to
tighten the filter housings—
use it only for loosening and
removing the filter housings.
6. CHECK THE MULTI-MEDIA
FILTER—The multi-media filter
is on the side of the AQUA
3
II
opposite the tubing receptacles,
and can be identified by the
number “2” embossed onto the
manifold. Unscrew the multi-
media filter housing counter-
clockwise, and set it aside. (If
necessary, use the housing
wrench supplied with your
AQUA
3
II to loosen the housing
(see figure 5).) The multi-media
filter will already be in place.