Rena Ware AQUA II 5000, Руководство пользователя

Страница: 22 / 28

When to replace the multi-media filter:
The flow-meter will indicate when to replace the multi-media filter. Please
refer to “VI. Replacing Components” at the back of this manual, for
instructions that pertain to your model.
1. Remove the body-cover
from the AQUA
3
II, and set
it aside.
2. Place the AQUA
3
II so
that the tubing receptacles
are over the sink. Gently
push in on the outlet tubing
(or white elbow if using a
spout), in the opening with
the white collar marked
with a (0). Slide the small
wrench around the outlet
tubing or spout elbow, with
the indented side of the
wrench facing the unit, and
while pushing in gently on
the white collar; pull out the
tube or spout elbow (see
figure 28/28a).
3. The multi-media filter is
labeled with a number “2”
embossed on the manifold
(see figure 29), opposite
the tubing receptacles.
Turn the multi-media filter
housing 1/4 to 1/2 turn
counter-clockwise and
—
allow the water to drain out
through the outlet opening
(see figure 30/30a). You
can tip the AQUA
3
II
slightly to further encourage
drainage. Remember
to hold the AQUA
3
II
firmly by the base when
repositioning or moving the
unit. (If necessary, use the
housing wrench to loosen
the filter housing.)
IV. Maintenance
(continued)
fig. 30
fig. 9
fig. 8
SPOUT MODEL
DOUBLE
DIVERTER VALVE
MODEL
(NON SPOUT)
2
SPOUT MODEL
DOUBLE
DIVERTER VALVE
MODEL
(NON SPOUT)
fig. 30a
fig. 8a