REMKO SLE 20, Операция, Технология, Запасные части.

Страница: 10 / 20

Status display LED
The LED on the front panel lights
up:
green = unit dehumidifies
red = the water container
(accessory) is full and must
be emptied
Defrosting
At room temperatures below 20°C,
the evaporator will start to frost
after a short time.
When the evaporator sensor
registers a temperature on the
evaporator surface that is lower
than 5°C, the unit will continue
to operate for about a further 44
minutes in dehumidification mode.
After lapse of this time, the fan
stops and the evaporator surface
is defrosted by the injection of hot
gas.
When the evaporator sensor
registers a temperature above
5°C, the compressor is switched
on again and the dehumidification
mode is restarted.
■
Switch the operating switch to
the “0” position (off)
■
In case of extended periods
of non use, the units must be
disconnected from the supply
■
If provided, the condensate
container must be emptied and
rinsed with clear water.
Attention should be paid
to subsequent dripping
condensate!
Decommissioning
■
Observe regular care and
maintenance intervals
■
Depending on the particular
operating conditions, the
units should be tested by an
expert for reliable operation as
necessary, but at least once a
year
■
Keep the unit free of dust and
other deposits
■
If the unit should be fouled, it
must be cleaned carefully and
thoroughly with suitable agents
■
If the evaporator tubes should
be heavily fouled, these can be
cleaned carefully with soapy
water
■
Do not use a direct jet of water,
e.g. high pressure cleaner, etc.
■
Do not use caustic cleaning
agents or those containing
solvents
■
Only use suitable cleaning
agents to remove heavy fouling
Care and maintenance
All moving parts are provided
with low-maintenance permanent
lubrication. The refrigeration
system is a hermetically sealed
system and must only be
repaired by authorised specialised
companies.
NOTE
Regular care and maintenance
is a basic precondition for a
long useful life and trouble-
free operation of the unit.
Cleaning the suction filter
The suction filter should be
checked at regular intervals and
cleaned if necessary.
The filter is fixed in a holder
behind the intake grilles.
■
A lightly clogged filter can be
cleaned by carefully blowing out
or using suction
■
A heavily clogged filter can
be washed in a luke warm
(maximum 40°C) soapy
solution. Subsequently rinse
thoroughly with clear water and
allow to dry
■
It must be ensured that the
filter is completely dry and
undamaged prior to refitting
■
The units must only be operated
with the filter fitted
Cleaning the condensate
water collecting tray
To ensure that the produced
condensate water is able to drain
freely, the condensate collecting
tray and the outlet must be
cleaned at regular intervals.
NOTE
Heavily clogged filters must be
replaced with new ones.
Only original spare parts must
be used.
ATTENTION
Regularly check the inlet and
outlet grilles as well as filters
for clogging.
10
REMKO SLE 20