REMKO SLE 20, Операция, Технология, Запасные части.

Страница: 9 / 20

Additional condensate
container
Where it is not possible or difficult
to provide a natural condensate
drain, the unit can be provided
with an additional condensate
container.
The container is available as an
accessory.
The condensate container is
mounted directly below the unit,
see diagram below.
When the unit is used with
condensate container, the
dehumidifier switches off
automatically when the container
is full.
An LED on the front panel shows
a steady “red” light when the
container is full and needs to be
emptied.
The condensate container consists
of the following parts:
■
Condensate container housing
with electromagnetic switch
for the water stop and cable
connection to the printed board
■
Condensate collecting container
■
4 fixing screws
Unit with condensate container
Mounting the condensate
container
■
Mount the unit on the supplied
wall bracket
■
After removing 2 screws at the
top of the unit, lift up the front
panel and remove it from the
unit horizontally
■
Screw the condensate container
housing below the unit with 4
fixing screws
■
Route the unit connecting cable
through the diaphragm sleeve
at the bottom of the condensate
container housing
Access to control:
The electronic control is located in
a housing in the centre of the unit.
Access to the control takes place
by removing the 4 screws on the
sides of the housing.
■
Route the cable of the
electromagnetic switch through
the diaphragm sleeve at
the bottom of the unit and
connection to terminal
13 and
14 on the control board
■
Refit the cover of the control
and front panel of the unit
■
Place the condensate container
in the condensate container
housing.
Position the condensate
container so that the float points
towards the electromagnetic
switch
Prior to each commissioning or
depending on the local conditions,
the air inlet and outlet grilles must
be checked for clogging.
After switching on with the
operating switch, the unit operates
via an integrated hygrostat set to
50% relative humidity (standard
value for indoor and outdoor
swimming pools).
The unit does not start at room
air conditions below 50% relative
humidity.
If the relative humidity is above
50%, the unit automatically starts
the dehumidification process.
To change the hygrostat setting if
necessary, the front panel must be
removed.
The hygrostat is located below the
electronic control.
Turning the control knob clockwise
reduces the humidity , turning
it anticlockwise increases the
humidity .
An external hygrostat (accessory)
can be fitted if required.
For connection options, see
“Electrical connection diagram”.
In order to prevent compressor
damage, the units are provided
with reclosing protection, which
prevents immediate reconnection
of the compressor after
disconnection.
The compressor initially switches
on again after a delay of about 45
seconds!
Commissioning
9