REMKO CLK 120, Инструкции по эксплуатации и монтажу, Страница: 20 / 28

20
REMKO CLK SERIES
After loosening the 4 fastening
bolts the mounting baseplate M is
pulled off the housing G.
The most important functional
parts for the installation/
maintenance are now immediately
accessible, as per the respective
requirements.
From size SL 44, 6 fastening screws
must be removed (note marking
arrows).
For maintenance work or for
installing/replacing the oil nozzle,
the mounting baseplate M can be
positioned on the burner housing
G in 2 ways (see figs. 1 and 2).
The baseplate can be positioned
in the desired/possible position
on the special mounting points in
accordance with the unit-specific
options.
Commissioning of forced-air oil burners
Required nozzle sizes
The selection of the required oil
nozzle is dependent on the pump
pressure and the unit capacity.
Only a nozzle that is approved
for the respective combustion
chamber geometry with
corresponding spray angle and
cone characteristics may be used.
Refer to the technical data for the
required oil nozzle size.
Air inlet nozzle
The required blower pressure can
be adjusted with the adjustable air
inlet nozzle A in accordance with
the combustion chamber resistance
and chimney draft, without having
to change the output diameter.
1. Loosen the Allen screw B.
2. Turn the air inlet nozzle A to the
desired position (note arrows!).
"min"
= Smaller blower pressure
"max" = Larger blower pressure
Mounting baseplate
After having replaced the nozzle
and carried out any adjustments
required to the air inlet nozzle A,
the mounting baseplate M is re-
fitted in reverse order.
Adjusting the ignition electrode and baffle plate
All sizes are approximate values and
are in mm. The optimum setting
must be adapted to the unit-
specific and structural conditions.
A
B
M G
M
G
Fig.: 2
Fig.: 1
Preparatory tasks
Size/dimensions A B C D
SLV 11 to SLV 33 5 5 7 3
SL 44 and SL 55
7 8 5 3
CAUTION
The commissioning of the
forced-air oil burner may
only be carried out by trained
specialists.
NOTE
Because the air flap, up to
size 44, is sprung this should
be closed beforehand with
the help of the adjustment
screw [3] (turn adjusting screw
approx. as far as scale value 1).
!