10
REMKO ATK
■
Use only clean EL heating oil or
diesel fuel. Beware of paraffin
formation!
■
Keep the burner head clean
■
Wear parts such as the oil
nozzle and seals must be
checked regularly and replaced
if necessary. The oil nozzle
must be replaced before the
start of each heating season!
■
Depending on its condition,
the fuel filter must be replaced
before each heating season.
Note the direction of flow!
■
Check that the safety devices
are operating correctly at
regular intervals
■
In the event of diminishing heat
capacity, smoke formation and/
or poor ignition, perform a unit
and burner inspection
Maintaining the burner
Clean the burner components as
described:
3. Remove the union nut [3] of the
oil pressure line from the nozzle
mounting.
Beware of dripping fuel!
4. Remove the locking screw from
the mounting plate [4] and, by
turning the plate [4] slightly
in an anti-clockwise direction,
remove the burner from
the burner pipe.
5. Clean the ignition electrodes
[6], baffle plate [7] and photocell
mounting [5].
6. Position the ignition electrodes
[6] in accordance with reference
values.
7. Following maintenance work,
refit all parts carefully in reverse
order.
NOTE
When positioning the baffle
plate [7], always ensure
that the aperture [5] is
not obscured by a strut on
the plate.
s
s
s
Cleaning the fuel tank
The fuel tank must be cleaned:
■
After each heating period
or earlier according to
the operating conditions
■
Before and after extended
periods out of operation
■
In the event of frequent
contamination of the fuel filter
■
In the event of condensate
formation in the fuel
■
Following paraffin precipitation
in the fuel tank
1. Unscrew the drain screw [D] and
drain the remaining (old) fuel
into a suitable container.
2. Rinse the fuel tank thoroughly
with clean heating oil or other
suitable agent (several times if
necessary).
Do not use water for rinsing!
3. Do not use solvent-based
cleaners.
This can damage the internal
coating of the fuel tank!
4. Avoid the use of pressure
washers.
5. After cleaning, replace the drain
screw [D].
The sealing ring [E] must be
replaced on each occasion!
6. The fuel tank must be filled
with clean heating oil or diesel
fuel.
Do not use biodiesel!
7. Start the unit and run for
approx. 5 min.
E
D
1. Remove the photocell [1] from
its mounting [5].
2. Disconnect the ignition cable [2].
2
4 6
3
1
5
7
Proceed as follows to clean the fuel
tank:
Содержание ATK 50-S
Страница 2: ......