!
▲
!
Do not operate this unit without guard over the suction fitting.
!
▲
!
The water in a whirlpool should never exceed 40˚ C (104˚ F). Water temperatures between
38˚ C (100˚ F) and 40˚ C (104˚ F) are considered safe for a healthy adult. Use time should
be limited to approximately 10 minutes, followed by a shower to cool down. Longer exposures
may result in hyperthermia, which can be fatal. The symptoms of this condition are nau-
sea, dizziness and fainting. Lower water temperatures are recommended for extended use
(exceeding 10 - 15 minutes) and for young children.
!
▲
!
Since excessive water temperatures have a high potential for causing fetal damage during the
early months of pregnancy, pregnant or possibly pregnant women should limit bath water tem-
peratures to 38˚ C (100˚ F).
!
▲
!
The use of drugs or alcoholic beverages before or during hydrotherapy bath use may lead to
unconsciousness with the possibility of drowning. Never use the hydrotherapy bath while under
the influence of alcohol, anticoagulants, stimulants, antihistamines, vasoconstrictors, vasodila-
tors, hypnotics, narcotics or tranquilizers.
!
▲
!
Persons with a medical history of heart disease, low or high blood pressure, circulatory system
problems, or diabetes should consult a physician before using a hydrotherapy bath.
!
▲
!
Persons using medication should consult a physician before using a hydrotherapy bath since
medication may induce drowsiness, affect heart rate, blood pressure and circulation.
!
▲
!
DANGER
: To reduce the risk of injury, enter and exit the bath slowly.
!
▲
!
WARNING
: Never operate electrically connected devices in or within 5' of the bath. Never drop
or insert any object into any opening within the hydrotherapy bath.
!
▲
!
DANGER
: Risk of electric shock. Connect only to circuits protected by a Ground Fault Circuit
Interrupter (GFCI). Such a device should be installed by a licensed electrician and should
be tested on a regular basis (at least monthly). To test the GFCI push the TEST button. The
GFCl should interrupt the power. Push the RESET button and the power should be restored.
lf the GFCI fails to operate in this manner there is the possibility of an electric shock. DO NOT
USE. Disconnect the unit and have the problem corrected by a qualified service technician.
To avoid the possibility of personal injury and discoloration of the acrylic surface, the inlet
water temperature should not exceed 60˚ C (140˚ F).
!
▲
!
DANGER
: Disconnect power before servicing.
!
▲
!
A pressure wire connector is provided on the exterior of the pump or control within this unit
to permit connection of a bonding conductor between this unit and all other exposed metal
in the vicinity, as needed to comply with local requirements.
INSTALLER/OWNER BEARS ALL RESPONSIBILITY TO COMPLY WITH ALL STATE
AND LOCAL CODES WHEN INSTALLING THIS PRODUCT.
!
▲
!
CAUTION:
Do not use harsh abrasives or solvents for cleaning this unit.
S AV E T H E S E I N S T R U C T I O N S
