C L E A N I N G I N S T R U C T I O N S
CLEANING INSTRUCTIONS FOR THE ACRYLIC SHELL
The cross-linked cast acrylic surface of all Reliance whirlpools, air baths and soaking baths is
among the glossiest, highest quality surfaces available. Its hard, non-porous surface prevents dirt
from accumulating and resists stains better than other materials. With normal use, cast acrylic will
retain its beauty with only a minimal amount of care. To maintain the high gloss, elegant look of the
cast acrylic surface, follow these simple steps:
1. Use common household,
non-abrasive
cleaners for most cleaning jobs (for example: a
mild dishwashing detergent such as Ivory Liquid). Follow manufacturer’s directions and
precautions. Rinse well and dry with a soft, clean cloth. Be sure to check the product label.
Some products, although not containing abrasives, WILL damage the acrylic over time.
Never use any type of “scrubbing bubbles” on your acrylic product unless it
specifically states that it is safe for use on acrylic!
2. Never use abrasive cleansers. If any product feels gritty when rubbed between your
fingers, do not use on the acrylic surface or controls as permanent damage will occur.
3. Do not allow your cast acrylic surface to come into contact with nail polish, nail polish
remover, Wintergreen oil, dry cleaning solution, lacquer thinners, gasoline, pine oil, etc.
4. Remove dust and dry dirt with a soft, damp cloth.
5. Clean grease, oil, paint or ink stains with isopropyl (rubbing) alcohol. Dry with a clean, soft
cloth.
6. Avoid using razor blades or other sharp objects that might scratch the surface. Small
scratches can be removed by applying a thin coat of automotive paste wax and buffing
lightly with a clean cloth. For deeper scratches, sand the surface lightly with a 400 grit “wet
or dry” paper and buff with a fine grit buffing compound.
MTI strongly recommends a professional acrylic repair person for deep scratches or chips.
CLEANING INSTRUCTIONS FOR WHIRLPOOL SYSTEMS
THE WHIRLPOOL SYSTEM SHOULD BE CLEANED PERIODICALLY. IT IS
RECOMMENDED TO CLEAN THE WHIRLPOOL PLUMBING SYSTEM AT LEAST
ONCE A MONTH, NOT TO EXCEED 90 DAYS BETWEEN CLEANINGS. ALWAYS USE
CAUTION WHEN USING CHLORINE-BASED PRODUCTS IN CONJUNCTION WITH
OTHER CLEANING PRODUCTS. THE POSSIBILITY OF HARMFUL FUMES COULD
RESULT. ALWAYS RINSE THOROUGHLY.
Fill tub with warm water 2” above the highest jet and add
one
of the following to the bath water: 1
cup vinegar,
or
several drops of a low sudsing detergent mixed with 1 cup warm water. Turn the
system on for five minutes then let stand for an additional 15 minutes. Drain the tub and refill with
cold water. Restart the system for 10 minutes then drain.
9
