Reisinger S 3000, Руководство по эксплуатации

Страница: 12 / 20

-
12 –
Parameter 51: Special functions: special input SI
0 – no function
1 – input (NO contact) SI activated – emergency opening in case of interlocking; door
OPENS
and
remains in this position, until SI is deactivated. This opening of the door is indicated by an
acoustic signal.
2 – input (NO contact) SI activated – opening in case of key lock time being active (P88 / P89)
3 – input (NO contact) SI activated – all current functions are interrupted and the door closes
4 – input (NC contact) SI activated – interlocking is deactivated.
PERMANENTLY OPEN
function
will change to partial opening
5 – input (NC contact) SI activated – Pull and go is deactivated; all current functions are interrupted
6 – input (NO contact) SI activated – door opens and remains in this position, until SI is deactivated
Parameter 52: Teach-in run is started without automatic speed ajustment
Parameter 53: Summer mode / winter mode
0 – Summer mode, total opening width
1 – Winter mode, reduced opening width at xx% (P54).
Parameter 54: Opening width for winter mode in %
Parameter 55: Closing time
0 – normal mode
1 – closing time mode, motion sensor Outside is deact ivated
Parameter 57: Automatic electrical lock
0 – deactivated
1 – active
Parameter 58: Interlock K1 as NO contact (0) or NC contact (1). K1 is activated at each opening of the door.
Parameter 59: 1 – after reversing door remains in open position until time (parameter 5) has elapsed
0 – after reversing door remains in open position until a key is pressed
Parameter 60: Status display
Parameter 61: Program selector
0 – deactivated
1 – active
Parameter 62: All parameters are reset back to works settings according to parameter list; after reset
carry out
teach-in run!
Parameter 63 Lighting effect display frame
0 – deactivated
1 – activated
Parameter 64 Fault and maintenance message via relay K2
1 – relay K2 as NO/NC contact opens/closes in case of a fault message or if maintenance is due
0 – deactivated
Parameter 65: Acoustic signal
0 – deactivated
1 – active
Parameter 66: Power-operated holding in OPEN and CLOSE limit position
0 – deactivated
1 – active
Parameter 70 Lock time closing time 1 : start (Motion sensor Outside is locked)
Parameter 71 Lock time closing time 1 : end (Motion sensor Outside is activated)
Parameter 72 Lock time closing time 2 : start (Motion sensor Outside is locked)
Parameter 73 Lock time closing time 2 : end (Motion sensor Outside is activated)
Parameter 74 Lock time closing time 3 : start (Motion sensor Outside is locked)
Par ameter 75 Lock time closing time 3 end (Motion sensor Outside is activated)
Parameter 76 Activation lock time closing time 1
0 – normal mode
1 – closing time mode