│
6
REGULUS - STDC E Controller - www.regulus.eu
C - Installation and wiring
C 1 - Wall installation
Install the controller only in dry areas.
Installation instructions:
1.
Unscrew cover screw completely.
2.
Carefully pull upper part of housing from lower part.
3.
Set upper part of housing aside, being sure not to
touch the electronics when doing so.
4.
Hold the lower part of the housing up to the
selected position and mark the 2 mounting holes.
Make sure that the wall surface is as even as possible
so that the housing does not become distorted when it
is screwed on.
5.
Mark the position on the wall. Using a drill and size
6 bit, drill 2 holes at the points marked on the wall and
push in the plugs. 4 holes can be used alternatively.
6.
Insert the upper screw and screw it in slightly.
7.
Fit the upper part of the housing and insert the other
screw.
8.
Align the housing and tighten the all screws.
Fig. C 1.1
Fig. C 1.2
fi
points
