19
│
REGULUS - STDC E Controller - www.regulus.eu
F 3 - Display mode
Menu
„3. Display mode”
is used to de
fi
ne the
controller’s display for normal operation.
This display appears whenever two minutes go by
without any key being pressed. The main menu
appears again when a key is pressed. The menu is
closed by pressing
„esc”
or selecting
„Exit display
mode”
.
F 3.1 - Schematic
In schematic mode, the selected hydraulic systems are depicted with the measured temperatures and
operating states of the connected consumers.
F 3.2 - Overview
In overview mode, the measured temperatures and operating states of the connected consumers are shown in
text form.
F 3.3 - Alternating
In alternating mode the schematic mode and then the overview mode are active for 5 seconds at a time.
F 3.4 - Display standby mode.
After 2 min. of inactivity the display goes to standby mode, turning off the illumination. The backlight does not
turn off when the on-screen error message or information message.
Setting range: On, Off / Default setting: Off
If a message or alarm is displayed, the backlight is not switched off until the message is read.
Caution
