Regin Regio Maxi, Руководство пользователя

Страница: 18 / 99

18
Part II
Installation
Chapter 5 Installation preparations
Using labels
On the back of the units’ electronics cassette, there is a set of labels which makes it easier to
install large numbers of Maxi controllers. By using the labels as carriers of information for
the installation engineer, much time will be saved and you can keep wiring errors at a
minimum.
Figure 1. Label on the back of the RCP-controller
Figure 2. Label on the back of the RU-unit
The three-piece label can be split and the parts can be fastened to the installation drawing
and the bottom plate of the controller. The label carries information on the communication
address etc., and has a note area where you can enter a reference number to the connection
diagram.
If you want to configure the RCP, it may be better to do this before sending the cassette to
the installation site. For more information about configuration, see the chapter
Configuration
.
The bottom plates with location and wiring information can be sent separately to the
installation site for electric installation.
Configuration
The RCP-controllers are configured using Regio tool
©
. For more information, see the manual
for Regio tool
©
. Some settings may also have to be made in the RU-unit. RU-models without
display have dipswitches that should be set, see the section
Dipswitches
below.
The computer with Regio tool
©
is connected to the bottom plate using E-cable. E-cable is
connected to terminal 41(A) & 40(B). 230 V AC is connected to L1 and N3.
Model and address
Field for new address or reference
to connection diagram
Field for room number
Model and address
Field for new address or reference to connection diagram
Field for room number