Regency Horizon HZ965E, Инструкция для владельца и по установке

Страница: 62 / 76

LIGHT BULB REPLACEMENT
The L965 comes with 2 accent lights in the rear of the fireplace. These are halogen lights that will need replacing from time to time, depending on use. They
can be purchased from most hardware stores or speciality lighting stores. The bulb specifications are:
Halogen bulb 120V 50W GY6.35 (lower wattages may be used).
Before replacing the light bulbs, let the unit cool completely to room temperature. In order to replace this bulb, you need
to remove the fireplace door, logs, burners and firebox liners. See each specific section in this manual for instructions
on how to remove these components. The light is situated in a light cover that is located on the back wall of the firebox.
To remove the light cover, lift the cover about ½” and pull towards you. Lift the old bulb from the socket and replace it
with the new bulb. It’s best not to contact the bulb with your hands. Oils from your skin will diminish the bulbs life. Use
paper or the wrapper that the bulb comes in to keep from touching the bulb. If you prefer, the bulb can be replaced
with a lower wattage if you’d like to reduce the bulbs effects in the firebox. Re-assemble the various components in
the reverse order.
Ensure the light covers are replaced prior to operating the appliance.
CLEANING / ANNUAL SERVICE:
The 965/HZ965will require maintenance, which can usually be planned on an annual basis. Service should include
cleaning, battery replacement, light replacement, venting inspection and inspection of the burner, log sets and firebox
liners. The venting systems should be periodically examined by a qualified agency.
CLEANING THE GLASS:
When the fireplace has cooled , remove the face of the fireplace along with the glass. See m
aIntenance
a
nD
s
ervIce
- g
lass
D
oor
r
emoval
. Check the gasket material on the back of the glass, making sure that
it is attached and intact.
During a cold start up, condensation will sometimes form on the glass. This is a normal condition with all fireplaces. However, this condensation can allow dust and lint to cling
to the glass surface. Initial paint curing of the appliance can leave a slight film behind the glass, a temporary problem. The glass will need cleaning about two weeks after
installation.
Use a mild glass cleaner and a soft cloth ; abrasive cleaners will damage the glass and plated surfaces. Depending on the amount of use, the glass should
require cleaning no more than two or three times a season.
Do not clean the glass when it is hot.
REPLACING GLASS:
The glass in the fireplace is a high temperature ceramic. If the glass is damaged in any way, a factory replacement is required (see P
arts
l
Ist
- c
omPonents
).
Wear gloves when handling damaged glass door assembly to prevent personal injury. When the glass door assembly is being transported, it must be wrapped
in newsprint and tape and/or a strong plastic bag. Do not operate with the glass front removed, cracked or broken. Removal and replacement of the glass
from the door
must be done by a licensed or qualified service person. The glass must be purchased from an authorized Regency dealer, part #50-2002.
No substitute materials are allowed.
BURNER & FIREBOX CLEANING:
The flow of combustion and ventilation air not to be obstructed. Periodic maintenance should include cleaning of the firebox, burner and log effects. Refer
to the sections on glass door removal, log and or burner installation to remove the glass door, log set (if equipped), burner trim pieces and burners. Using a
vacuum with a soft brush attachment, clean out any dust, lint or debris from the floor of the firebox. Using a soft brush, gently remove any dirt or debris from
the top surface of the burner. Using the same brush, gently brush away any carbon deposits that have built up on the surface of the logs. Re-install all of these
components as shown in the setup / installation portion of this guide. Clean both surfaces of the window glass using commercial glass cleaner and clean soft
cloths. Securely re-install the glass door onto the fireplace.
Figure 118: Replacing Light Bulb.
62
| HZ965/L965 Gas Fireplace
|
62
maintenance