Regency
®
E21-10 Gas Fireplace Insert
|
27
|
27
operating instructions
LIGHTING
PROCEDURE
Important: If the pilot does not hold, turn pilot knob
to "OFF" position. Wait 5 minutes to clear gas. If
you smell gas - STOP! Follow the safety information
above. If you don't smell gas, repeat Steps 1-6.
1
. Push in gas control knob slightly and turn to
"PILOT" position.
2
. Push in control knob all the way and hold in
until the pilot lights up. Continue to hold the
control knob in for about 20 seconds after the
pilot is lit. Release knob.
3.
Push in gas control knob slightly and turn to
"ON" position.
4
. Ensure the receiver is in the remote position.
IMPORTANT
Prior to igniting or re igniting
the pilot, remove the glass
door.
Set Switch to
Remote
5
. Press and release the ON/OFF button on the
remote handheld transmitter. An audible beep
should be heard from the receiver.
ON/OFF
Button
6.
The unit will turn on.
SHUTDOWN
PROCEDURE
1
. Press "OFF" on the remote or slide receiver
switch from remote to "OFF".
2
. Turn the gas control knob to the "OFF" position
to turn off the pilot.
Pilot may be shut off during prolonged non use
periods to conserve fuel.
Diagram 2
Remote shown in Manual Mode on Hi
Diagram 1
Содержание E21-LP10
Страница 32: ...32 Regency E21 10 Gas Fireplace Insert 32 notes ...
Страница 33: ...Regency E21 10 Gas Fireplace Insert 33 33 notes ...
Страница 34: ...34 Regency E21 10 Gas Fireplace Insert 34 notes ...
