Reflex Refexomat RSC, Руководство по эксплуатации

Страница: 52 / 70

Controller
Reflexomat with Basic controller — 20.06.2017 - Rev. C English — 43
9.2.1 Default settings
The device controller is shipped with the following default settings. Use the Customer menu to adjust these values to local conditions. In
specific cases, it is possible to further adjust the values in the Service menu.
Customer menu
Parameter Setting Remarks
Language EN Display language.
Minimum operating pressure "P
0
" 1.8 bar see chapter 7.2 "Determining the P
0
minimum operating
pressure for the controller" on page 33 .
Next maintenance 12 months Time left to the next due maintenance.
Floating alarm contact YES see chapter 9.2.2 "Messages" on page 44 .
Make-up
Make-up “ON” 8 %
Make-up “OFF” 12 %
Maximum make-up quantity 0 Litres Only if make-up has been selected in the customer menu
with “With water meter Yes”.
Maximum make-up time 30 minutes
Maximum make-up cycles 6 cycles within 2 hours
Softening (Only if "With softening Yes")
Lock make-up No In the case of soft water residual capacity = 0
Hardness reduction 8°dH = Target – Actual
Maximum make-up quantity 0 Litres
Soft water capacity 0 Litres
Cartridge replacement 18 months Replace cartridge.
Service menu
Parameter Setting Remarks
Pressurisation
Compressor "ON" P
0
+ 0.3 bar Differential pressured added to the "P
0
" minimum
operating pressure.
Compressor "OFF" P
0
+ 0.4 bar Differential pressured added to the "P
0
" minimum
operating pressure.
"Compressor run time exceeded" message 240 minutes The message is displayed after the compressor runs for
240 minutes.
Overflow line "CLOSED" P
0
+ 0.4 bar Differential pressured added to the "P
0
" minimum
operating pressure.
Overflow line "OPEN" P
0
+ 0.5 bar Differential pressured added to the "P
0
" minimum
operating pressure.
Maximum pressure P
0
+ 3 bar Differential pressured added to the "P
0
" minimum
operating pressure.
Filling levels
Insufficient water "ON" 5 %
Insufficient water "OFF" 12 %
Solenoid valve in overflow line "CLOSED" 90 %