34
PowerMast by ReechCraft
• Using a four-foot level, adjust the stabilizers on the outriggers until the base is level
front to back and side to side. (See Figure 3.14)
• With the base level, lower the two center stabilizers so they rest on the ground.
(See Figure 3.14)
Leveling the Base
Important:
This is the normal position the outriggers should be in to achieve the full
ratings of the system. Consult your local dealer or ReechCraft customer service for
information on alternative configurations.
Important:
The main base is designed to carry the majority of the machine weight and
duty loads. The outriggers are designed to stabilize tipping loads. It may be necessary to
adjust the stabilizers slightly after full setup to add more preloading on the stabilizers.
101 in. (2565 mm)
75 in. (1905 mm)
Figure 3.13
- Outrigger Footprint
3.1
Erecting the Freestanding System
Setting the Outriggers
SECTION
3
ERECTING THE SYSTEM
• Adjust the position of the outriggers to create the footprint shown in Figure 3.13.
Rear Outriggers
Center Stabilizers
Front Outriggers
Figure 3.14
- Leveling the Base