PowerLift
by ReechCraft
54
7.5
Decal Replacement
All decals must be mounted to the machine as specified and clearly legible.
Please see Figure 5-1 to Figure 5-4 and refer to table 5-1 for positions and
ReechCraft part numbers.
To replace a damaged decal, first remove it completely without damaging the
underlying surface.
Remove any remaining adhesive with a suitable solvent. Test the solvent on an
inconspicuous area first to ensure it does not mark or damage the surface finish.
SURFACE DAMAGE COULD RESULT IN CORROSION AND STRUCTURAL
DAMAGE.
Before applying the new decal, ensure the surface is clean and dry.
Remove the backing paper, apply the decal along one edge then seal it gently
and evenly.
If there are any air bubbles, work them gently towards the edge with a clean cloth.
Pressure sensitive adhesives reach full strength after several days.
MAST SECTIONS SHOULD BE INSPECTED EVERY 3 MONTHS OR MORE
FREQUENTLY DEPENDING ON ENVIRONMENT
The Mast Track sections should be inspected more frequently if used in a harsh
environment or high duty cycle applications. Inspection should be more frequent
as they approach the end of their useful lives. The periodic inspection shall cover
all mast track sections on the machine.
Mast Track sections must be replaced by an Authorized ReechCraft Service
Center.
Conditions such as the following shall be sufficient reason for questioning
continued use of the machine or increasing the frequency of inspection.
DANGER
NOTICE
CAUTION
WARNING
DANGER
NOTICE
CAUTION
WARNING
7.6
Mast Track Inspection Procedure
SECTION
7
SERVICE & MAINTENANCE
