PowerLift
by ReechCraft
58
TROUBLE
PROBABLE CAUSE
REMEDY
Platform does not lift up from the fully lowered position - Drill motor starts
One or more interlocks are
engaged
Check to be sure all four outriggers
are properly installed extended and
stable.
Overload clutch is slipping
Be sure the rated load of 159 kg is
not exceeded and that the platform
is free and clear of any obstruction
or interference.
One or more interlock pins are
wedged in the locked position
Lower platform to the fully lowered
position to relieve pressure, ensure
all leveling jacks are stable and
bearing equal weight.
Platform will not move when in elevated position - Drill motor starts
Intermediate mast section is
installed backwards with the track
section facing away from the
platform
Lower the platform and reinstall the
mast section with the track section
facing the platform.
One or more of the connector lock
levers are in the open position
interfering with the rollers
Lower the platform to expose
the last section of mast that was
installed and check to be sure both
levers are completely engaged and
locked in position.
The maximum height has been
attained causing interference with the
top termination plate
No remedy. System is functioning
properly.
Platform moves sluggishly
Drive Shaft brake is engaged
Depress the input shaft slightly
before applying power to release
the brake.
Drill battery not fully charged
Charge battery
Drill has insufficient power or RPM
Be sure the drill contains a motor of
7 amps and 1200 RPM or more.
Machine does not wheel properly
One or more castors are in the
locked position
Unlock the castor
One or more castors are damaged
Replace the damaged castor
Climbing Unit jumps or lurches while elevating
Track is damaged and missing
teeth
Replace the track section*
*Performed by Authorized ReechCraft Service Center
TROUBLESHOOTING
Figure 8-1
Troubleshooting Guide
SECTION
8
TROUBLESHOOTING
