Redsail CM-Series, Руководство пользователя

Страница: 27 / 33

Chapter 5 Software Installation and Operation
5.1 Software Installation
Please insert the software CD into the computer, install the software in CD. Please
read the control system user manul for more information for this section.
5.2 Software Operation
Before using the device, please read this user manual and the control system user
manual carefully, know all functions for the software, please refer to the control system
user manual for the detail operation.
Chapter 6 Machine Operation
6.1 Before operation, please put the working materials on the working table of the device.
(Note: Keep the working materials flat, otherwise will affect the working result)
6.2 Press “Up, Down, Left, Right” key on the control panel to move the laser head to the
suitable position according to the original working position which is set up in the software,
it should be coincident, then press “Origin” key to fix the original position for laser head
6.3 Adjust the focal length (Attched figure 1)
6.4 Press “Start” key to start the work.
Chapter 7 Machine Maintenance and Note
The key of normal and stable work for laser equipment is do routine maintenance and
maintenance of equipment. If it has Good maintenance not only can extend the service
life of machine, reduce equipment failure rates, but also can improve product quality. In
order to use this equipment better, please read the following brief introduction for routine
maintenance of laser equipment and precautions for reference.