Redsail CM-Series, Руководство пользователя

Страница: 23 / 33

Steps:
The first step: Regulate test power to below 50%, to keep the power not too high.
The second step: Optical path adjustment between laser rube and the first reflecting
mirror.
Put the test paper (paper self-adhesive tape) in front of the first reflecting mirror, then
press “Pulse/Run ”button slightly(loose immediately after pressing slightly, only you can
see the spot on the test paper), then check whether there is a spot in the center of the first
reflecting mirror. If in the center, you have finished the first step. If there is no spot or the
spot is not in the center, please adjust the location and the height of the first reflecting
mirror holder (or laser tube) to meet above standard. (Below Figure)
1· Masking paper（choose the test paper for adjust the laser beam） 2·Test spot 3·First Reflecting
Mirror Holder 4·Adjusting screw 5·Laser Tube
The third step: Optical path adjustment between the first and the second reflecting mirror.
First of all, put the test paper(paper self-adhesive tape) in front of the mirror of the
second reflecting mirror holder, using direction keys on the control panel to move the
track to the top left corner, press "Pulse/Run" key and check the location of the spot.
Then move the track to the lower left corner，press "Pulse/Run" key again, To check
whether the two spots( the top left corner and the lower left corner) coincide with each