4
INTRODUCTION
This is an engine-driven transfer pump for use in general de-watering applications and is suitable for pumping clear water. Do not use the pump in
applications where sewage or any other debris (gravel, sand, floating debris, etc.) or corrosives are present.
This instruction sheet provides you with the information required to safely own and operate your product. Retain these instructions for future reference.
The product you have purchased is of the highest quality workmanship and material, and has been engineered to give you long and reliable service. This
product has been carefully tested, inspected, and packaged to ensure safe delivery and operation. Please examine your item(s) carefully to ensure that no
damage occurred during shipment. If damage has occurred, please contact the place of purchase. They will assist you in replacement or repair, if required.
SPECIFICATIONS
Model
2RLAG-1L
Engine
Air Cooled, 4 Stroke, OHV, 79cc
Performance
2.1 HP @ 3600 rpm
Fuel Type
Refer to engine manufacturer's owner's manual
Oil Type
Refer to engine manufacturer's owner's manual
Shut Off
79 ft (24.1 m)
Suction head (max.)
25 ft (7.6 m)
Intake Size
1.5" MNPT (3.8 cm)
Discharge Size
1.5" MNPT (3.8 cm)
Maximum Flow
60 GPM (227 LPM)
Weight
43 Lb (19.5 kg)
Height
17.75" (45.1 cm)
Width
14" (35.6 cm)
Length
20.75" (52.7 cm)
APPLICATION
Use this pump for water only,
where the vertical suction head from the water level is 25 ft (8m) or less. Do not exceed the maximum suction head.
Head refers to the height of a column of water that can be delivered by the discharge of the pump (Figure 1). Suction head (or suction lift) is the
vertical distance between the center of the pump and the surface of the liquid on the suction side of the pump. Discharge head is the vertical distance
between the pump's discharge port and the point of discharge. Total head is the sum of the suction head and the discharge head. The elevation above
sea level and friction losses must be taken into consideration.
