RedHotDot 013643, Инструкция по эксплуатации

Страница: 6 / 25

MMAX7
6
EN
This equipment does not comply with IEC 61000-3-12 and is intended to be connected to private low-voltage
systems interfacing with the public supply only at the medium- or high-voltage level. On a public low-voltage
power grid, it is the responsibility of the installer or user of the device to ensure, by checking with the operator
of the distribution network, which device can be connected.
This equipment complies with IEC 61000-3-11 if the power supply network’s impedance at the electircal
installation’s connection point is inferior to the network’s maximum admissible impendance Zmax:
Reference
MMAX7
Zmax admissible 0.25 Ohms
ELECTROMAGNETIC INTERFERENCES
The electric currents flowing through a conductor cause electrical and magnetic fields (EMF). The welding
current generates an EMF field around the welding circuit and the welding equipment.
The EMF fields may disrupt some medical implants, such as pacemakers. Protection measures should be taken
for people wearing medical implants. For example, access restrictions for passers-by or an individual risk
evaluation for the welders.
All welders should take the following precautions in order to minimise exposure to the electromagnetic fields (EMF)
generated by the welding circuit:
• position the welding cables together – if possible, attach them;
• keep your head and torso as far as possible from the welding circuit;
• never enroll the cables around your body;
• never position your body between the welding cables. Hold both welding cables on the same side of your body;
• connect the earth clamp as close as possible to the area being welded;
• do not work too close to, do not lean and do not sit on the welding machine
• do not weld when you’re carrying the welding machine or its wire feeder.
People wearing pacemakers are advised to consult their doctor before using this device.
Exposure to electromagnetic fields while welding may have other health effects which are not yet known.
RECOMMENDATIONS TO ASSESS THE WELDING AREA AND WELDING INSTALLATION
Overview
The user is responsible for installing and using the arc welding equipment in accordance with the manufacturer’s instructions.
If electromagnetic disturbances are detected, it is the responsibility of the user of the arc welding equipment to resolve the
situation with the manufacturer’s technical assistance. In some cases, this remedial action may be as simple as earthing the
welding circuit. In other cases, it may be necessary to construct an electromagnetic shield around the welding power source
and around the entire piece by fitting input filters. In all cases, electromagnetic interferences must be reduced until they are no
longer bothersome.
Welding area assessment
Before installing the machine, the user must evaluate the possible electromagnetic problems that may arise in the area where
the installation is planned.
In particular, it should consider the following:
a) The presence of other power cables (power supply cables, telephone cables, command cable, etc...) above, below and on
the sides of the arc welding machine.
b) Television transmitters and receivers;
c) Computers and other hardware;
d) Critical safety equipment such as industrial machine protections;
e) The health and safety of the people in the area such as people with pacemakers or hearing aids;
f) Calibration and measuring equipment
g) The isolation of the equipment from other machinery.
The user will have to make sure that the devices and equipments that are in the same room are compatible with each other.
This may require extra precautions;
h) Make sure of the exact hour when the welding and/or other operations will take place.
The surface of the area to be considered around the device depends on the the building’s structure and other activities that take
place there. The area taken in consideration can be larger than the limits determined by the companies.