RED LOTUS HYDRO, Инструкция по установке и эксплуатации

Страница: 35 / 72

1
7-INITIAL START-UP
33
Technical Dept. - All rights reserved - Reproduction is prohibited
This is absolutely normal as the structure is made of laminated steel and must not be considered a defect.
It is extremely important to make sure the product is not immediately overheated and the temperature is increased gradually, initially
using low power.
This will prevent damaging the ceramic or serpentine tiles, the welds and the steel structure.
DO NOT EXPECT HEATING EFFICIENCY IMMEDIATELY!!!
ATTENTION!
If during operation or initial ignition you encounter smoke spillage in to the room from the appliance
or the flue then please switch off the appliance, ventilate the room and contact the installation / service
engineer immediately.
OPENING/CLOSING THE DOOR
ATTENTION!
The door must be closed properly for the stove to work correctly.
"Use suitable Personal Protective Equipment (e.g. gloves) to open the stove door.
To open the door, lift the hook, as shown in the figure"
SETTINGS TO BE CARRIED OUT BEFORE THE INITIAL START-UP
Once the power cable is connected in the rear part of the stove, turn the switch, also placed at the rear, to position (
I
). To switch the stove
on or off press key
1
on the control panel.
DOOR OPENING.