N-Tron® 300 Series Hardware Guide
2-7
Installation
Revised 2015-12-04
DIN-Rail Mounting
Install the unit in a standard DIN-Rail. Recess the unit to allow at least 5” of horizontal clearance for fiber optic
cable bend radius (2” for TX models).
To install the unit to 35mm industrial DIN-Rail,
place the top edge of the included mounting
bracket on the back of the unit against the DIN-
Rail at a 15° angle as shown. Rotate the bot-
tom of the unit to the back (away from you)
until it snaps into place.
To remove the unit from the 35mm industrial DIN-
Rail, place a flat head screwdriver into the orange
release clip found at the bottom of the unit, and apply
downward force on the clip until it disengages from
the bottom of the unit from the DIN-Rail. Rotate the
bottom of the unit towards you and up at an approxi-
mate 15° upward angle to completely remove the
unit.
All N-Tron 300 series products are designed to be mounted on industry standard 35mm DIN-Rail.
However, DIN-Rail mounting may not be suitable for all applications. We offer three alternative
mounting solutions: the 300 Panel Mount Assembly (P/N: 300-PM), the 900 Panel Mount Assembly
(P/N: 900-PM), and the Universal Rack Mount Kit (P/N: URMK). These may be used to securely
mount
302MC, 304TX, 305FX, 306FX2, 306TX, and 308TX units to a panel or standard 19" rack
.
300-PM 900-PM
URMK
