Recognition Systems HandPunch 50E, Руководство пользователя

Страница: 36 / 58

Programming the HandPunch
Page 34
Setup Menu
The Setup menu commands allow you to set the basic operating
parameters for the HandPunch unit. The following section provides a
brief summary of all the parameters that may be set on a HandPunch
unit.
In most cases only the Ethernet Setup needs to be done in this
menu.
Once in the Command Menu, you can step through and set the
parameters for each command sequentially. You do not have to exit
command mode after setting any individual command.
Navigating
the Setup
Command
Menu Enter the appropriate password to enter the Setup command menu.
Once you have entered the command menu, there are three options
available for navigating the command menu system.
• Press to enter the command shown on the display.
• Press to step to the next command in the menu.
• Press to exit the command menu (pressing any numeric
key also exits the command menu). If you are in a command’s sub-
menu, press multiple times to completely exit the
command menu.
Setup
Commands There are six commands available from the Setup command menu.
• Set Language
• Set Date Format
• Set Date and Time
• Set ID Length
• Set Serial
Refer to Table 6 on page 35 and identify the command you need to
perform. Step through all previous commands until you reach the
desired command.
NOTE
#
*
CLEAR
CLEAR