Recognition Systems HandPunch 1000, Руководство пользователя

Страница: 54 / 70

Appendix C
Page 52
5. Align a bubble level with the top edge of the wall plate and gently rotate the
wall plate until the bubble level shows that the top edge of the wall plate is
level.
6. Secure the plate to the wall using heavy masking tape.
7. Using the wall plate as a template, mark the locations of the two upper screw
holes and the three lower screw holes.
8. For a concealed wiring connection, trace the outline of the open area in the
center of the wall plate. Identify and mark a 1/2 inch hole through which the
HandPunch’s wiring will be mounted.
9. For a surface conduit wiring connection, mark the two conduit clamp holes
at the right side of the wall plate.
10. Remove the wall plate, masking tape, and the nail (if used).
Mounting
the Wall
Plate
1. For a hollow wall, use the provided hardware to mount the wall plate. Use the
two auger style fasteners for the upper two mounting holes. Use the toggle
bolts for the three lower mounting holes.
2. For a solid wall, use expansion bolts to mount the wall plate. For all five
mounting holes, drill a 1/4 inch diameter hole, 1/4 of an inch deeper than the
length of the expansion anchor.
Routing the
Wiring
1. Refer to Figure 12-2 on page 52 for a template diagram to assist in routing
wiring.
2. For a concealed wiring connection, drill a 1/2 inch hole in a convenient loca-
tion within the open area of the wall plate. Pull the wiring to enter the Hand-
Punch through this hole in the open area.
3. For a surface conduit wiring connection, drill a 1/4 inch diameter hole, 1/4 of
an inch deeper than the length of the expansion anchor for each of the two
conduit clamp holes. Route 1/2 inch, flexible conduit to the HandPunch, end-
ing the conduit between the two conduit clamp holes. Pull the wiring to enter
the HandPunch through the conduit. Pull 18 inches of wire past the end of
the conduit to allow enough space for final connection to the HandPunch.
4. Clear all dust and debris away from the HandPunch mounting location.