REC N-Peak 2 Black Series, Руководство по установке

Страница: 15 / 31

REC Installation Manual - REC Solar Panels - IEC 61215 / 61730
Rev L - 09 . 21 Ref: PM - IM -20
15
250 mm [9.8 in]
100 mm [3.9 in]
0
0
250 mm [9.8 in]
100 mm [3.9 in]
0
650 mm [25.6 in]
250 mm [9.8 in]
100 mm [3.9 in]
0
0
250 mm [9.8 in]
100 mm [3.9 in]
0
650 mm [25.6 in]
CAUTION
The center point of each clamp and the minimum grip length must be fully located in the same clamping zones to be rated to that load (fig. 10 ).
If the panel is secured in zones with di ff erent load values, it is rated to the lowest load value only.
Rail positioning
Rail positioning
Fig. 10 : Clamping of REC N-Peak 2 Series panels with rails parallel to long side of the panel
Rail position
Rail position
MOUNTING REC N - PEAK 2 SERIES PANELS WITH CONTINOUS RAILS PARALLEL TO LONG SIDE OF THE PANEL
A continous rail (or other support structure) spans the complete underside of the panel.
Legend
Clearance Gap
Clamping zone
20-40 mm 40-60 mm > 60 mm < 20 mm
Test Load
(Design Load)
Test Load
(Design Load)
Test Load
(Design Load)
Test Load
(Design Load)
0 - 650 mm
+ 1200 Pa / -1200 Pa *
(+ 800 Pa / -800 Pa)
+ 3000 Pa / -2400 Pa
(+ 2400 Pa / -1600 Pa)
+ 5400 Pa / -2400 Pa
(+ 3600 Pa / -1600 Pa)
X
0 - 100 mm X
+ 1200 Pa / -1200 Pa *
(+ 800 Pa / -800 Pa)
+ 1600 Pa / -1600 Pa *
(+ 1066 Pa / -1066 Pa)
X
100 - 250 mm X
+ 800 Pa / -800 Pa *
(+ 533 Pa / -533 Pa)
+ 2400 Pa / -2400 Pa
(+ 1600 Pa / -1600 Pa)
X
Once a module is secured in each of the 4 zones (fig. 2 ), additional clamps, i.e., ≥5 , may be freely located on panel frame without
a ff ecting the warranty. Loads marked with a
*
were not certified as part of IEC 61215 / 61730 testing; these have been evaluated by
REC’s internal testing process.
Sh
or
t S
id
e
M
ou
nt
in
g
Lo
ng
S
id
e
M
ou
nt
in
g