Rears Pakblast 50 Gal, Руководство пользователя

Страница: 32 / 58

Pak-Blast
50 gallon
14
With a new belt installed, instructions on previous page ,
the idler pulley should be positioned as illustrated above.
Loosely tighten the idler tension assembly mount bolt A ,
accessible inside the fan housing .
Grip the tension assembly body B with a wrench and
rotate counter clockwise to tension the idler arm.
Align the 15° mark on the body B with the INDEX
POINT , see fig ii . The INDEX POINT is the corner of the
idler arm.
Hold this tension and tighten assembly mount bolt A .
Rotate belt in both directions to set properly. The belt
should be nearly centered on the idler pulley.
The belt
must not hang over the edge of the idler pulley.
CHECK NEW BELT TENSION AT 4 & 8 HOURS.
CHECK WEEKLY AFTER BREAK IN.
tension micro-v fan belt drive
for A58 fan belt, see following section
SHUT DOWN TRACTOR, SET BRAKE
AND REMOVE KEY WHEN WORK-
ING ON SPRAYER. NEVER OPERATE
SPRAYER WITH GUARDS MISSING.
ALWAYS SUPPORT SPRAYER DURING
MAINTENANCE: SET ON GROUND OR
PLATFORM. NEVER WORK ON SUS-
PENDED IMPLEMENT.
30°
0°
30°
15°
15°
INDEX
0° 15°
30°
30°
15°
fig i
fig ii
fig iii
A
B
CHEMICAL CONTAINERS INC.
800 346 7867