INSTRUCTIONS FOR:
S P R AY G U N
Model:
NA2000
Thank you for purchasing a National Machinery product. Manufactured to a high standard this product will, if used according to these
instructions and properly maintained, give you years of trouble free performance.
NA2000 - 1095 - (1) - 180400
1. SAFETY INSTRUCTIONS
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.
USE THIS PRODUCT CORRECTLY, WITH CARE AND FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
2. DESCRIPTION & SPECIFICATION
3
Familiarise yourself with the application and limitations of this product, as well as the potential hazards.
p
WARNING!
Disconnect the spray gun from the air supply before changing accessories, servicing or performing any maintenance.
3
Maintain the spray gun in good condition (use an authorised service agent).
3
Replace or repair damaged parts.
Use recommended parts only. Non-authorised parts may be dangerous and will invalidate the warranty.
3
Keep the spray gun clean for best and safest performance.
3
Ensure the air system is capable of supplying enough air for the spray guns air consumption.
3
Wear approved safety respiratory protection, safety eye goggles and latex gloves to protect against the harmful effects of paint spray.
3
Remove ill fitting clothing. Remove ties, watches, rings, and other loose jewellery, and tie back long hair.
3
Locate the spray gun in an adequate working area, keep area clean and tidy and free from unrelated materials, and ensure there is
adequate ventilation and lighting.
3
Keep children and unauthorised persons away from the working area.
3
When not in use ensure the air supply is turned off.
3
Avoid unintentional starting.
7
DO NOT
point spray gun at yourself, other persons or animals.
7
DO NOT
carry the by the hose, or yank the hose from the air supply.
7
DO NOT
use the spray gun for any purpose other than for which it is designed.
7
DO NOT
allow untrained persons to operate the spray gun.
7
DO NOT
operate the spray gun if any parts are missing or damaged as this may cause failure and/or personal injury.
7
DO NOT
direct air from the air hose at yourself or others.
3
When not in use disconnect the spray gun from the air supply.
The NA2000 is a suction feed spray gun which has adjustable air, fluid and spread controls.
SPECIFICATION
NA2000 Suction Spray Gun
Air pressure, max. . . . . . . . . . . .116psi (8 bar)
Air consumption, max. . . .7cfm (200 litres/min)
3.1. Ensure the air valve is in the "off" position before connecting to the air supply.
3.2. You will require a minimum air pressure of 65psi/4.5 bar to operate the gun.
p
WARNING!
Ensure air supply is clean and does not exceed 116psi/8 bar. Too high an air pressure or unclean air will shorten
the life of the gun due to excessive wear and may be dangerous, possibly causing damage and/or personal injury.
3.3. Drain the air supply tank daily. Water in the air line will damage the gun and contaminate the paint.
3.4. Clean the air inlet filter screen weekly. For recommended
hook-up, see diagram to right.
3.5. Line pressure should be increased to compensate for
unusually long air hoses (over 8 metres). The minimum
hose diameter should be 10mm I.D. and fittings must
have the same inside dimensions.
3.6. Keep hose away from heat, oil and sharp edges.
Check hoses for wear, and make certain that all
connections are secure.
3.7. The input connection on the gun is 1/4 BSP.
3. AIR SUPPLY
HOOK UP
fig. 1
