Real Carriage Door & Sliding Hardware Edison Sliding Opener, Руководство по установке

Страница: 24 / 28

Page 24 Accessories
Real Carriage Door & Sliding Hardware Copyright 2020© all rights reserved
Please see below diagram (Red
arrow is showing the location of
USART)
Note: Homelink installation video is available
on YouTube. Just search “HomeLink training for
Sommer garage door openers”.
Homelink Programming
1. For the first time programming press and hold
all 3 Homelink buttons for 30 seconds
2. Release only when the homelink indicator light
turns off
3. To ensure Homelink is in training mode press
and hold each of the buttons individually
4. Indicator light blinks rapidly for 2 seconds and
then turns to continuous light
5. At the carriage locate the radio button
6. Press and release the
radio button
7. LED light is activated
8. Return the carriage
and firmly press
and hold the desired
Homelink button to be programmed for 2
seconds and release
9. Repeat the press/hold/release sequence a
second time to activate the door
10. You may need to repeat this sequence for
pressing radio button on the motor carriage
and then pressing the Homelink button in the
vehicle up to 3 times to complete the training
process
11. Homelink should now activate the rolling code
equipped opener
Battery Pack
• Battery pack can
supply power during
power failure
• Battery pack can be
operated for approx. 5
cycles in 12 hours
Note : It is recommended to have a qualified
electrician to install, test and replace battery pack
• Battery pack contains charging and monitoring
hardware
Please see below diagram (Red arrow is showing
the location of ACCU for install)
MEMO
• Memory extension from 40 commands up to
450 commands
• Easy to install and will work without
programming (plug and play)
• When plugged in the MEMO transfers data
from internal memory to the MEMO and stores
information
• The MEMO must be remained plugged in. At
any time the data can be transferred back to
the internal memory or deleted