Page 16
Installation
Real Carriage Door & Sliding Hardware Copyright 2020© all rights reserved
For Side-wall applications
Header Brackets and Mounting
• Attachment must be to adequate framing or
strapping
• Drywall only attachment is not permitted
• The track must not come into contact with the
door’s supporting sliding track at any time
• The curved brace may be rotated for maximum
flexibility in the install
• When sliding hardware is on the same side as
the opener the opener must be ceiling mounted
or mounted on a bump out ledger to gain
clearance over the sliding hardware.
1. Place the rail into each header bracket over the
chain tensioner or wire connector
2. Insert pin into the header bracket and tensioner
with the holes lined up
3. Secure with c-clips
Ataching the Door Bracket
1. Position door bracket in the desired location on
the door
2. Swivel the
boomerang arm
and the u-fitting
assembly to
determine the best
placement
3. Mark the location
of the brace’s two
mounting holes
4.
Cut the door bracket to length (if desired) and
plug the end with the cap provided
5. Install the bracket onto the door with the hex
head lag screws provided
6.
Pre-drill through the bracket where the U-Fitting
meets it (this position will change depending on
application)
7. Securely fasten the u-fitting to the bracket with
a 1” x ¼” hex head bolt and nut
Mounting the Control Unit
The control unit housing must be mounted at least
5ft from the ground, within 16.4ft of the open end
of the rail and no more than 5.7ft (69”) from an
outlet. These distances cannot be
extended.
1. Loosen the screw on the cover
of the control unit and gently
remove the cover by lifting
upwards
2. Unplug the connection cable
for the membrane keypad from the control unit
• See page 11 for instructions on removing the
cover
3. Transfer the mounting points to the wall by
drilling two pilot holes 4.55” (4-11/20”) apart
•
1/4” pilot holes that are 1.6” deep (40mm)
Содержание Edison Sliding Opener
Страница 1: ...Edison Sliding Opener Installation Manual...
