www.ReadyLIFT.com
-
Phone: (877) 759
-
9991
8
44
-
3060/44
-
3080IM
-
AC
Once the torsion key is adjusted
high enough, remove the cross pin.
DO NOT push it through with your
finger
. Always pull it out away from
the keyway. Once the cross pin is
out, remove the torsion bar unload-
ing tool.
Push the torsion bar forward through
the factory keyway cross member
and lower control arm. You may
need to use a hammer and punch.
Hammer on the end of the bar to
break it loose from the keyway and
control arm. Remove the factory
Key.
Loosen but do not remove the outer
tie rod end nut at the knuckle. Strike
the tie rod boss with a dead blow
hammer to dislodge the taper. Re-
move the tie rod after this has been
completed.
Using a torsion bar unloading tool
(ReadyLIFT part #66
-
7816A) or simi-
lar Relieve the pressure on the tor-
sion key cross pin. Take care as the
torsion key is under extreme pres-
sure and can cause injury and/or
death if handled improperly. Always
use safety equipment.
