www.ReadyLIFT.com
-
Phone: (877) 759
-
9991
14
44
-
3060/44
-
3080IM
-
AC
Torque all diff hardware
95 ft
-
lbs
starting with the driver and passenger
side upper hardware first. Then driver lower hardware. When tightening
the passenger side lower hardware, makes sure to
“
center
”
the bracket in
the diff
’
s slotted mount. Verify that the diff clears the frame cut made earli-
er. If not, trim more frame material out until a minimum
1/4”
clearance is
gained. The frame should rest right inside the divot in the diff housing be-
tween the middle and last bolt bosses.
Install the front drive shaft using the
factory hardware
and a drop of
thread locker for each bolt. Torque
to
15 ft
-
lbs
. Reconnect the electrical
connector, install the wire harness to
the original locations, attach the vent
tube.
Install the ReadyLIFT front and rear
cross member. Use the
factory con-
trol arm and cross member hard-
ware
. Do not tighten at this time.
Install the lower control arms to the
ReadyLIFT cross members using the
provided
M18 bolts, washers, and
nuts
. Do not tighten at this time.
