RCm KILO, Инструкция по эксплуатации и техническому обслуживанию

Страница: 22 / 47

22
Pad holder driving disc (only for KILO versions with disc brush base)
Proceed as follows for assembly/disassembly of the pad holder driving disc (A) with pad (B) on the machine provided
with appropriate base:
Tighten/loosen the ring nut (C) to assemble/disassemble the pad (B) on the pad holder driving disc (A).
!
ATTENTION!
Always check there are no foreign bodies between the base (E) and the machine, which can obstruct lifting of
the base, before activating the ignition key (D).
Assembly of pad holder driving disc
1. Sit on the machine seat and rotate the ignition key (D) to “I”, then wait a few seconds until the caption (H)
“Ready” appears on the display (G).
2. Wait for the base (E) to lift and the luminous indication (I) to turn off .
3. Rotate the ignition key (D) to “0” and extract it.
4.
Position the pad holder driving disc (A) with pad (B) under the base, centring it on the coupling hub.
5. Sit on the machine seat and rotate the ignition key (D) to “I”, then wait a few seconds until the caption (H)
“Ready” appears on the display (G).
6. Press the activation button (J) to lower and rotate the pad holder driving disc.
7. Press the accelerator (K) lightly and only for an instant, thereby lowering the hub that will couple the pad
holder driving disc.
If the pad holder driving disc is not coupled climb down from the machine and reposition the pad holder
driving disc on the coupling hub, which should have remained lowered (thereby easing alignment); then
repeat the operations described in the previous points 5, 6 and 7.
8. The pad holder driving disc (A) is coupled and ready for use; if necessary, turn the machine off by rotating the
ignition key (D) to “0” and extract it.
!
ATTENTION!
Use of the machine with the pad holder driving disc not perfectly assembled can cause injury to people and
damage to equipment.
Always ensure all components have been assembled before starting the machine. Carefully inspect the ma-
chine before using it.
Disassembly of pad holder driving disc
1. Sit on the machine seat and rotate the ignition key (D) to “I”, then wait a few seconds until the caption (H)
“Ready” appears on the display (G).
2. Press the pad holder driving disc release button (L) and wait for a few seconds until the machine has released
the pad holder driving disc after having activated it for an instant.
3. Rotate the ignition key (D) to “0” and extract it.
4. Slightly move the squeegee (M) and recover the pad holder driving disc.
A E
M
K
D
C
L
H
G
I
J
A
C
B