RCm KILO, Инструкция по эксплуатации и техническому обслуживанию

Страница: 30 / 47

30
EMPTYING OF TANKS
Emptying of recovery water tank
1. Take the machine to the intended area for disposal of the recovery water, in compliance with the emission stand-
ards in force.
2. Rotate the machine's ignition key to “0” and extract it.
3. Disengage the tube (A) from its seat and lift it above the upper edge (B) of the tank until its zone (C) is free from
water, then keep it in this position and unscrew the cap (D).
4. Manually bend the tube in the zone (C) until a watertight bend (E) is obtained, then keep it bent and lower it on
the drain zone.
5. Gradually (to avoid unwanted splashes) release the bend (E) so that the dirty water fl ows from the tank into the
drain zone.
6. Use the grip (F) to lift the tank cover (G) and, if necessary, wash the recovery water from the tank (H) (see the
procedure in the Maintenance chapter).
7. Tighten the cap (D) and engage the tube (A) in the relative seat of the machine.
Emptying the detergent solution (or washing water) tank
1. Take the machine to the intended area for disposal of the detergent solution (or washing water), in compliance
with the emission standards in force.
2. Rotate the machine’s ignition key to “0” and extract it.
3. Open the tap (I) so that the detergent solution (or water) fl ows out from the tank into the drain zone.
4. If necessary, wash the detergent solution (or water for washing) tank after unscrewing the cap (P).
5. After washing the tank, close the tap (I) and screw the cap (P) back on.
!
Danger! Frost Hazard
With temperatures of 0°C or below, check and eventually fully remove water from tanks and hoses at the end
of each job or if the machine is unused for a certain period of time.
E
D
C
A
G
F
H
P
B
C M
I