LIF200 User Manual
5
2.2.
LED status
LED
Color(s)
Activity
Description
POWER
Red
Off
Power OFF
On
Device Ready
LINK
Red
Off
No Ethernet Link
On
Ethernet Link established
100M
Red
Off
10 Mbps
On
100 Mbps
TRANS
Green
Off
No TCP/IP session link
On
TCP/IP session link established
Blinking
Booting/System Self-Test
Data Sending/Receiving between Serial and Ethernet
2.3.
Initial Setup
Set up your computer by assigning it a static IP address in the 192.168.168.1 to
192.168.168.254 range with a subnet mask of 255.255.255.0. This is necessary to ensure that
your computer can communicate with your LIF-200.
Your computer must have an Ethernet card and TCP/IP installed. TCP/IP should already be
installed on computer using Windows 98/2000/XP and later operating systems.
Note: To connect a computer directly to the LIF-200 Ethernet port use a crossover Ethernet cable, if both the
computer and the LIF-200 are connected to a hub/switch use a straight-through Ethernet cable.
2.3.1. Fixed IP Addresses Configuration
For details please refer to Section 3 Basic Configuration Setup.
2.3.2. Configure your LIF-200
For details please refer to Section 4 Advanced Configuration Setup.
